Front Bumper Cover / Fascia: Service and Repair

Bumper Cover - Front

Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist.

2. Remove the front wheels and tires.

3. If equipped, remove the 2 front stone deflector extension retainers on both sides from inside the front wheel wells.





4. If equipped, remove the 2 bolts and both of the front stone deflector extension.





5. Remove both front fender splash shields.

6. Disconnect the front bumper cover from the bumper cover brackets.
1. Remove the 3 front bumper cover-to-front bumper cover bracket bolts on both sides.
- To install, tighten to 8 Nm (71 lb-in).

2. Gently pull down on the front bumper cover to disconnect it from the bumper cover brackets on both sides.






7. If equipped, disconnect the auxiliary parking lamp electrical connectors.

8. Remove the front bumper cover bolt on the underside of vehicle.





9. Remove the 4 upper radiator grille reinforcement-to-radiator support pin-type retainers and remove the front bumper cover assembly.





10. To install, reverse the removal procedure.
- Transfer all necessary components.