Interior Light Switch: Service and Repair

Ambient Lighting Switch









Removal and Installation

1. Remove the floor console LH finish moulding.

2. Remove the floor console RH finish moulding.

3. Remove the four cup holder screws.

4. Lift the cup holder up and position the cup holder rearward.

5. Ignition in the run position.

6. Shift the gear sleector lever to the low position.

7. Remove the four selector lever trim panel screws.

8. Lift the selector lever trim panel up and position the selector lever trim panel rearward.

9. Remove the four media bin/storage compartment screws.

10. Raise the media bin/storage compartment and disconnect the following electrical connectors:
- power point.

- sun shade (if equipped).

- ambient lighting switch.

11. Remove the media bin/storage compartment.

12. Release the tabs and remove the ambient lighting switch.

13. To install, reverse the removal procedure.