Parking Assist Distance Sensor: Service and Repair

Parking Aid Sensor









Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.

2. Remove the rear bumper cover. For additional information, refer to Bumper.

3. Disconnect the parking aid sensor electrical connectors.

4. NOTE: Gently pry the retaining tabs on the parking aid sensor bezels to release the sensor(s).

Remove the parking aid sensor(s).

5. To install, reverse the removal procedure.
- Carry out the azimuth and elevation system check. For additional information, refer to Azimuth System Check Azimuth System Check and Elevation System Check Elevation System Check.