Seat Cushion Heater Mat - Rear

Seat Cushion Heater Mat - Rear

Removal

NOTICE: The heater mat is not designed to be separated from the foam pad. Doing so will damage the foam pad. Install a new foam pad and heater mat. Failure to follow this instruction can result in seat component damage and system failure.

NOTE: For parts identification and location, refer to Seat - Exploded View, Second Row Seat - Exploded View, Second Row.

1. Remove the rear seat cushion cover. For additional information, refer to Seat Cushion Cover - Rear Seat Cushion Cover - Rear.

2. Disconnect and remove the heated seat module and cushion wire harness.

3. Remove the cushion foam pad from the frame. Discard the cushion foam pad with heater mat.

Installation

1. Install new cushion heater mats onto a new cushion foam pad.

1. Position a cushion heater mat onto the cushion foam pad so the opening aligns to the clips in the cushion foam pad.

2. Tuck the cushion heater mat into the cushion foam pad trenches.

3. Make sure the cushion heater mat stays in place, remove the paper strips from under the cushion heater mat and adhere to the cushion foam pad, laying it flat with no wrinkles.

4. Route the cushion heater mat wire harness and electrical connector through the cushion foam pad to the other side.





2. Install and connect the cushion wire harness and heated seat module.

3. Install the rear seat cushion cover. For additional information, refer to Seat Cushion Cover - Rear Seat Cushion Cover - Rear.