Antenna Cable - AM/FM

Antenna Cable - AM/FM

NOTE: Only the front AM/FM antenna cable is shown.

NOTE: The glove compartment is shown removed for clarity.











Removal

NOTE: Both the front and rear AM/FM antenna cables are part of the vehicle wiring harness. Because the cables cannot be removed from the harness, this procedure applies to replacement of the cables only.

Front cable

1. Remove the Audio Control Module (ACM). For additional information, refer to Audio Control Module (ACM) Audio Control Module (ACM).

Rear cable

2. Remove the headliner.

3. Disconnect the rear AM/FM antenna cable from the antenna module.

4. Remove the RF and RR door sill trim panels.

Both cables

5. Disconnect the front-to-rear AM/FM antenna cable connection at the RH kick panel.

6. Cut the ends of the existing cable and tape them back to prevent NVH concerns.

Installation

Both cables

1. Overlay the new AM/FM antenna cable on the vehicle wiring harness, following the routing of the original cable.

2. Secure the new AM/FM antenna cable with tape or zip ties, as necessary.

3. Connect the front-to-rear AM/FM antenna cable connection at the RH kick panel.

Front cable

4. Install the ACM. For additional information, refer to Audio Control Module (ACM) Audio Control Module (ACM).

Rear cable

5. Install the RF and RR door sill trim panels.

6. Connect the rear AM/FM antenna cable to the antenna module.

7. Install the headliner.