Removal and Replacement

Bumper Cover - Rear

Removal and Installation

1. Remove the 6 mudflap screws.

2. Remove the 4 rear bumper cover lower valence-to-rear bumper cover pin-type retainers.

3. Remove the 2 rear bumper cover lower valence W-base clips.

4. Disconnect the electrical connector from inside the luggage compartment and reposition the rear bumper cover.
- Feed the wiring harness through the rear of the vehicle.

5. Remove the rear bumper cover.
- Pull outward on the sides of the bumper cover to release the bumper cover from the bumper cover brackets.

- Pull rearward to remove the bumper cover.

6. To install, reverse the removal procedure.