Removal and Replacement

Engine Mount













Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.

2. Remove the engine coolant degas bottle. For additional information, refer to Cooling System &/or Engine Block Heater.

3. Install the Engine Support Bar to the front and rear engine lifting eyes.





4. Remove the bolt and the engine mount damper.
- To install, tighten to 23 Nm (17 lb-ft).

5. Remove the bolt and the ground wire.
- To install, tighten to 10 Nm (89 lb-in).

6. Remove the engine mount bracket bolt.
- To install, tighten to 115 Nm (85 lb-ft).

7. Use the Engine Support Bar to raise the engine 25 mm (0.98 in).





8. Remove the 2 engine mount bracket nuts.
- To install, tighten to 103 Nm (76 lb-ft).

9. Remove the nut, 2 bolts and the engine mount.
- To install, tighten to 55 Nm (41 lb-ft).

10. NOTE: If the engine mount bracket is to be removed, the engine must be lowered to avoid contact between the A/C tubes and the engine mount bracket.

Use the Engine Support Bar to lower the engine 25 mm (0.98 in).

- Remove the engine mount bracket.

11. To install, reverse the removal procedure.