Parking Brake Control: Service and Repair

Parking Brake Control









Removal and Installation

1. Remove the floor console. For additional information, refer to Instrument Cluster / Carrier &/or Interior Moulding / Trim.

2. Make sure the parking brake control is in the released position.

3. Disconnect the warning indicator switch electrical connector.

4. Loosen the parking brake control adjusting nut.

5. Remove the 2 parking brake control nuts.
- To install, tighten to 20 Nm (177 lb-in).

6. Remove the parking brake control bolt and the parking brake control.
- To install, tighten to 20 Nm (177 lb-in).

7. To install, reverse the removal procedure.
- Adjust the parking brake cable. For additional information, refer to Parking Brake Cable Adjustment Adjustments.