Pinpoint Test G: The (BLIS(TM)) and (CTA) Cannot Be Turned Off In The Instrument Panel Cluster (IPC) Message Center

Blind Spot Monitoring

Pinpoint Tests

Pinpoint Test G: The Blind Spot Information System (BLIS(TM)) and Cross Traffic Alert (CTA) System Cannot Be Turned Off In The Instrument Panel Cluster (IPC) Message Center

NOTE: The CTA system customer ON/OFF feature in the Instrument Panel Cluster (IPC) is not available on early build hybrid vehicles.

Normal Operation

The Side Obstacle Detection Control Module - Right (SOD-R) and Side Obstacle Detection Control Module - Left (SOD-L) communicate over the Medium Speed Controller Area Network (MS-CAN) with the Instrument Panel Cluster (IPC). The Blind Spot Information System (BLIS(TM)) and the Cross Traffic Alert (CTA) system can be turned on and off through the message center which is part of the IPC. The CTA system cannot be disabled in the message center when the transaxle selector gear is in REVERSE (R).

NOTE: The BLIS(TM) and/or CTA system are turned off for one key cycle only when using the message center switches. Permanently disabling the BLIS(TM) and/or CTA system is carried out in the Integrated Diagnostic System (IDS) programmable parameters menu.

This pinpoint test is intended to diagnose the following:

- IPC
- SOD-R
- SOD-L



PINPOINT TEST G: THE BLIS(TM) AND CTA SYSTEM CANNOT BE TURNED OFF IN THE IPC MESSAGE CENTER

-------------------------------------------------
G1 CHECK THE DTCs FROM BOTH THE CONTINUOUS AND ON-DEMAND IPC, SOD-R AND SOD-L SELF-TESTS


- Check the IPC, SOD-R and SOD-L DTCs from the continuous and on-demand self-tests.
- Are any IPC, SOD-R or SOD-L DTCs recorded?

Yes
For IPC, REFER to Instrument Panel, Gauges and Warning Indicators. REPAIR all IPC DTCs and RETEST the BLIS(TM) and CTA system for normal operation.

For SOD-R or SOD-L DTCs, REFER to the DTC Charts. Blind Spot Monitoring

No
GO to G2.

-------------------------------------------------
G2 CHECK THE MESSAGE CENTER FOR CORRECT OPERATION


- Check the IPC message center for correct operation, while turning the BLIS(TM) and CTA system off and on.
- Does the message center operate correctly?

Yes
The system is operating correctly at this time.

No
REFER to Instrument Panel, Gauges and Warning Indicators to diagnose the IPC message center not operating correctly.

-------------------------------------------------