Seat Cushion Cover - Second Row, 40 Percent

Seat Cushion Cover - Second Row, 40 Percent, Taurus X

Removal and Installation

Power-fold seat

1. Remove the seat. For additional information, refer to Seat - Rear, Second Row, Taurus X Seat - Rear, Second Row.

2. Position the seat forward on the seat track and release the 2 forward trim cover J-clips.





3. Release the hook-and-loop strips from the bottom side of the cushion trim cover.





Manual-fold seat

4. Place the seat in the E-Z entry position.

All seats

5. Release the outer and inner J-clips at the rear of the cushion trim cover.

6. Release the 2 cushion trim cover side retainers and remove from between the cushion frame and seat track.
- Un-curl the retainer ends and push through the opening between the cushion frame and riser/seat track.





7. Manually lock the inboard seat-to-floor latch and raise the backrest.
- For manual-fold seat, lower and lock the seat to the floor.

8. Invert and remove the cushion trim cover from the cushion foam pad.
- Route the bottom trim cover flap through the seat track adjust handle.

- Remove the hog rings.

- Carefully route the cushion trim cover rear flap from between the backrest and cushion.

9. To install, reverse the removal procedure.
- Make sure the child safety seat attaching points are accessible.