Alternator: Service and Repair

Generator - 4.0L SOHC









Removal and Installation

1. Disconnect the battery.

2. Rotate the Front End Accessory Drive (FEAD) belt tensioner counterclockwise and position the FEAD belt aside.

3. Disconnect the generator electrical connector.

4. Position the generator B+ protective boot aside, remove the nut and position the generator B+ terminal aside.
- To install, tighten to 17 Nm (150 lb-in).

5. Remove the generator stud nut.
- To install, tighten to 48 Nm (35 lb-ft).

6. Remove the 2 bolts and the generator.
- To install, tighten to 48 Nm (35 lb-ft).

7. To install, reverse the removal procedure.