Horn: Service and Repair

Horn









Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist.

2. Remove the 6 pin-type retainers and the upper radiator sight shield.

3. Remove the 4 bolts and the 2 radiator support brackets.
- To install, tighten to 10 Nm (89 lb-in).

4. Position the top of the radiator and condenser assembly toward the engine.

5. Remove the 2 horn bracket nuts.
- To install, tighten to 9 Nm (80 lb-in).

6. If equipped, remove the 6 front bumper cover-to-valance panel screws and remove the valance panel.

7. Disconnect the electrical connector and remove the horn.

8. To install, reverse the removal procedure.