Harmonic Balancer - Crankshaft Pulley: Service and Repair

Crankshaft Pulley









Removal

1. With the vehicle in NEUTRAL, position it on a hoist.

2. Remove the Air Cleaner (ACL) outlet pipe.

3. Remove the accessory drive belt.

4. NOTE: This bolt is torque-to-yield and cannot be reused.

Using the Strap Wrench, hold the crankshaft pulley, remove the bolt and washer.





5. NOTE: If the pulley bolt is not installed, the Crankshaft Vibration Damper Remover will bottom out before the pulley is off.

Install the crankshaft pulley bolt 2 to 3 turns. Using the Crankshaft Vibration Damper Removers and the two 8-mm bolts, remove the crankshaft pulley.

- Discard the crankshaft pulley bolt.





Installation

1. Using the Crankshaft Vibration Damper Installer, install the crankshaft pulley.





2. Using the Strap Wrench, hold the crankshaft pulley, install a new crankshaft pulley bolt. Tighten the bolt in 2 stages.
- Stage 1: Tighten to 55 Nm (41 lb-ft).

- Stage 2: Tighten an additional 85 degrees.





3. Install the accessory drive belt.

4. Install the ACL outlet pipe.