Back Window Motor: Service and Repair

Window Regulator Motor - Rear









Removal and Installation

NOTE: The power rear window motor must be initialized when repairs are performed on any part of the power rear window system including when: the power rear window motor is removed from the window regulator drum housing, a new power rear motor is installed, a new power rear window regulator is installed, a new power rear window glass module is installed, and any operation in which grease or lubricants are applied to the power rear window system.

1. Remove the rear window glass regulator. For additional information, refer to Window Regulator - Rear Service and Repair.

2. Remove the 3 window regulator motor bolts.
- To install, tighten to 4 Nm (35 lb-in).

3. Remove the window regulator motor.

4. To install, reverse the removal procedure.
- Initialize the power rear window motor. For additional information, refer to Window Motor Initialization - Rear Window Motor Initialization - Rear.