Selector Lever Knob

Selector Lever Knob









Removal

1. Remove the front floor console. For additional information, refer to Instrument Cluster / Carrier &/or Interior Moulding / Trim.

2. Disconnect the Transmission Control Switch (TCS) electrical connector and feed the wire through the selector lever housing.





3. Slide the selector lever knob lower trim cover downward.





4. Remove the set screw and remove the selector lever knob while routing the TCS harness out of the selector lever housing.





Installation

1. NOTICE: Do not overtighten the set screw or damage to the selector lever knob may occur.

Install the selector lever knob and set screw while routing the TCS harness through the selector lever housing.

- Tighten to 3 Nm (27 lb-in).





2. Slide the selector lever knob lower trim cover upward.





3. Feed the wire through the selector lever housing and connect the TCS electrical connector.





4. Install the front floor console. For additional information, refer to Instrument Cluster / Carrier &/or Interior Moulding / Trim.