Power Steering Pump Pulley

Power Steering Pump Pulley - 4.0L









Removal and Installation

1. Disconnect the fan clutch electrical connector, remove the fan clutch wiring harness bracket bolt and position the harness aside.
- To install, tighten to 7 Nm (62 lb-in).





2. Loosen the 3 power steering pump pulley bolts.

3. Rotate the tensioner and remove the engine accessory drive belt from the power steering pump pulley.

4. Remove the 3 bolts and the power steering pump pulley.
- To install, tighten to 25 Nm (18 lb-ft).

5. To install, reverse the removal procedure.