Parking Brake Shoe: Service and Repair

Parking Brake Shoes









Removal

NOTE: A parking brake shoe kit contains the linings required for both the LH and RH side.

1. NOTE: Make sure the parking brake control is fully released.

Release the tension on the parking brake cable. For additional information, refer to Parking Brake Cable Tension Release Procedures.

2. Remove the rear brake disc. For additional information, refer to Disc Brake System.

3. Remove the parking brake shoe adjusting screw.

4. Remove the parking brake shoe adjusting screw spring.

5. Remove the 2 parking brake shoe hold-down springs and pins.

6. Remove the parking brake shoe retracting spring and the parking brake shoes.

Installation

1. Position the parking brake shoes and attach the retracting spring.

2. Install the 2 parking brake shoe hold-down pins and springs.

3. Install the parking brake shoe adjusting screw spring.

4. NOTE: Completely retract the parking brake adjusting screw before installation.

Install the brake shoe adjusting screw.

5. Adjust the parking brake shoe. For additional information, refer to Parking Brake Shoe Adjustment Adjustments.

6. Reload the tension on the parking brake cable. For additional information, refer to Parking Brake Cable Tension Release Procedures.