Seat - Second Row, 60/40 Bench

Seat - Second Row, Explorer, 60/40 Bench





40 Percent Seat

NOTE: When installing any seat-to-floor bolts or floor studs, apply threadlock.











60 Percent Seat

NOTE: When installing any seat-to-floor bolts or floor studs, apply threadlock.











Removal

NOTE: When removing the 60 percent seat, the 40 percent seat must be removed first to gain access to the 60 percent seat-to-floor fasteners.

40 and 60 percent seats

1. Remove the 40 percent seat front seat-to-floor bolts.

2. With the 40 percent seat in the normal sitting position, lift the seat cushion up for access to the 40 percent seat rear retainers.

3. Remove the rear retainers and 40 percent seat from the vehicle.

60 percent seat

4. Remove the tether-to-floor bolt (if equipped).

5. Remove the 60 percent seat front seat-to-floor bolts.

6. With the 60 percent seat in the normal sitting position, lift the seat cushion up for access to the 60 percent seat rear retainers.
- Pull the safety belt buckles through the 60 percent seat cushion opening.

7. Remove the rear retainers and 60 percent seat from the vehicle.

Installation

60 percent seat

1. Position the 60 percent seat in the vehicle.
- Position the safety belt buckles through the 60 percent seat cushion opening.

2. NOTE: Before installation, make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.

Tighten the retainers in the sequence shown.

1. Tighten to 40 Nm (30 lb-ft).

2. Tighten to 55 Nm (41 lb-ft).

3. Apply threadlock and tighten to 40 Nm (30 lb-ft).

4. Apply threadlock and tighten to 40 Nm (30 lb-ft).

5. Apply threadlock and tighten to 40 Nm (30 lb-ft).

6. Apply threadlock and tighten to 40 Nm (30 lb-ft).

7. Apply threadlock and tighten to 55 Nm (41 lb-ft).





40 and 60 percent seats

3. Position the 40 percent seat in the vehicle.

4. Tighten the retainers in the sequence shown.

1. Apply threadlock and tighten to 40 Nm (30 lb-ft).

2. Apply threadlock and tighten to 55 Nm (41 lb-ft).

3. Tighten to 40 Nm (30 lb-ft).

4. Apply threadlock and tighten to 40 Nm (30 lb-ft).

5. Apply threadlock and tighten to 40 Nm (30 lb-ft).

6. Apply threadlock and tighten to 40 Nm (30 lb-ft).