H7

H7 CHECK FOR INTERMITTENT HIGH RESISTANCE

- Key "OFF."

- Install the EEC IV 60-Pin Breakout Box.

Harness Side Of Rear Brake Anti-lock Sensor Connector:

- Connect a jumper wire between the two circuits on the harness side of the Rear ABS sensor.

- Monitor the resistance between pins 9 and 21 of the breakout box while driving over rough roads.

NOTE: Turn the beeper of the multimeter on to help detect any large changes in the continuity as the drive test is performed.

Is an intermittent high resistance indicated?

> Yes
Repair circuit 519 (LG/BK) or circuit 523 (R/PK). H9

> No
H8