Malfunction Lamp / Indicator: Testing and Inspection

SRS WARNING LIGHT INSPECTION

1. Check to be sure that the SRS warning light illuminates when the ignition switch is in the ON position.

2. Check to be sure that it illuminates for approximately 7 seconds and then switches off.

3. If the above is not the case, inspect the diagnostic trouble codes.

INSPECTION CHART FOR TROUBLE SYMPTOMS

Get an understanding of the trouble symptoms and check according to the inspection procedure chart.





INSPECTION PROCEDURE FOR TROUBLE SYMPTOMS









1. Turn the ignition key to the "LOCK" position, disconnect the negative battery cable and tape the terminal.

Caution: Wait at least 60 seconds after disconnecting the battery cable before doing any further work. Air Bags Precautions

2. Remove the floor console assembly.

3. Place a flat-tipped screwdriver against the lock spring at the lock lever notch and push the spring toward the unit.

Caution: Do not use excessive force to raise the lock lever (green).