Starter - Installation

5.7L ALL WHEEL DRIVE (AWD)





1. Position starter (1) into transmission but do not install bolts (2).





2. Connect the solenoid harness connector (1) to starter motor (snaps on).
3. Position the battery cable to solenoid stud (2). Install and tighten battery cable eyelet nut to 11 Nm (97 In. Lbs). Do not allow starter motor to hang from wire harness.
4. Install and tighten both mounting bolts (4). Tighten the bolts to 54 Nm (40 Ft.Lbs).





5. Install steering gear assembly and mounting bolts (4). [1][2]Specifications for torque specifications.
6. Install the steering gear intermediate shaft (1). Intermediate Shaft - Installation
7. Install steering gear heat-shield.
8. Lower the vehicle.
9. Connect the negative battery cable.

10. Start the engine to verify the starter is functioning properly.
11. Turn the ignition off.