Rear Bumper Fascia - Removal

REMOVAL






NOTE: Base model shown, SRT models similar.

1. Disconnect the negative battery cable.
2. Raise and support the vehicle.
3. Remove the three push-pin retainers (2) that secure each rear wheel house splash shield to the rear fascia assembly.
4. Remove the fastener (1) that secures the rear fascia assembly to the rear quarter.
5. Remove the fastener (3) that secures the rear fascia assembly to the rear fascia support bracket.
6. Repeat the removal steps on the opposite side.





7. Remove the taillamp, Tail Stop Turn Lamp - Removal. Repeat on opposite side.
8. Remove the fastener (1) located in the taillamp cavity that secures the fascia (2) to the rear quarter. Repeat for opposite side.
9. Pull out on the fascia (2) at the wheel house opening to disengage the fascia from the retaining bracket. Repeat on the opposite side.





10. With the help of an assistant, pull rearward to disengage the fascia (1) from the rear retaining bracket. Do not completely remove at this time.
11. Disconnect the vehicle wiring harness.
12. With the help of an assistant, remove the fascia (1) from the vehicle.