Rear Bumper Fascia - Installation

INSTALLATION






NOTE: Base model shown, SRT models similar.

1. With the help of an assistant, position the fascia (2) to the vehicle.
2. Connect the vehicle wiring harness.
3. With the help of an assistant and using firm pressure, align and push forward to engage the fascia to the rear retaining bracket.





4. Install the fastener (1) located in the taillamp cavity that secures the fascia (2) to the rear quarter. Tighten the fastener securely. Repeat for opposite side.
5. Align the fascia (2) with the retaining bracket and using firm pressure push in to engage. Repeat on the opposite side.
6. Install the taillamp, Tail Stop Turn Lamp - Installation. Repeat on opposite side.





7. Install the three push-pin retainers (2) that secure each rear wheel house splash shield to the rear fascia assembly.Repeat for opposite side.
8. Install the fastener (1) that secures the rear fascia assembly to the rear quarter. Tighten the fastener securely. Repeat for opposite side.
9. Install the fastener (3) that secures the rear fascia assembly to the rear fascia support bracket. Tighten the fastener securely. Repeat for opposite side.
10. Connect the negative battery cable.