A/C And Heater Control - Removal

REMOVAL

WARNING: Disable the airbag system before attempting any steering wheel, steering column or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.

NOTE: Take the proper precautions to protect the front face of the center bezel from cosmetic damage while performing this procedure.






NOTE: MTC A/C-heater control shown. ATC A/C-heater control similar.

1. Disconnect and isolate the negative battery cable.
2. Remove the instrument panel center bezel (3) and place it on a workbench Instrument Panel Center Bezel - Removal.
3. Remove the four screws (1 and 4) that secure the A/C-heater control (2) to the back of the center bezel and remove the control.