Exhaust Manifold - Installation

ALL WHEEL DRIVE (AWD)





1. Install a new maniverter gasket. DO NOT APPLY SEALER.
2. Position maniverter (1) in place. Tighten fasteners, starting at center and progressing outward in both directions to 34 Nm (300 in. lbs.). Raise and lower vehicle for fastener access as necessary. Repeat tightening procedure until all fasteners are at specified torque.




3. Install coolant adapter (3)Engine Coolant Thermostat - Installation.




4. Install maniverter heat shields (3). Tighten bolts (1) to 12 Nm (105 in. lbs.).




5. Install maniverter (2) support bracket and tighten bolts (1).




6. Install exhaust pipe to maniverter bolts (1). Tighten bolts to 28 Nm (250 in. lbs.).




7. Install oxygen sensor (2) and connect electrical connector.




8. Install engine cover (1).




9. Install the air cleaner housing (1)Air Cleaner Housing - Installation.
10. Connect cables on battery (3).




11. Position air cleaner inlet (2) and tighten retainers (5).
12. Top off the fluids.