Knee Blocker Airbag - Installation

INSTALLATION





1. Connect the knee blocker airbag electrical connector by pushing firmly until it snaps into place.




2. Position the knee blocker airbag with trim cover (5) in the instrument panel cavity.
3. Reach up behind the instrument panel and install the two outer knee blocker airbag retaining nuts (3). Tighten nuts to 10.5 Nm (93 in. lbs.). If the middle nut was removed by accident, this is the smaller flanged nut than the outside nuts to allow it to pass through the larger middle hole.
4. Install the two knee blocker airbag cover (5) screws (4).

WARNING: DO NOT CONNECT THE BATTERY NEGATIVE CABLE. PERSONAL INJURY OR DEATH MAY RESULT IF THE SYSTEM TEST IS NOT PERFORMED FIRST. FOR THE SYSTEM TEST, Supplemental Restraints Verification Test