Driver Airbag - Installation

INSTALLATION





1. Connect the squib wires (3) to the driver airbag (4). Make airbag connection by pressing straight in on the connector. The connector should be fully seated. Feel for positive snap to assure positive connection.
2. Position the driver airbag (4) in the steering wheel (2) and push forward.

NOTE: Make sure not to pinch any wires underneath the driver airbag.

3. Install the two airbag retaining bolts (1). Tighten bolts to 10 Nm (89 in. lbs.).
4. Install the airbag bolt access covers.

WARNING: DO NOT CONNECT THE BATTERY NEGATIVE CABLE. PERSONAL INJURY OR DEATH MAY RESULT IF THE SYSTEM TEST IS NOT PERFORMED FIRST. FOR THE SYSTEM TEST, Supplemental Restraints Verification Test