Liftgate Spoiler - Installation

INSTALLATION

NON SRT 4





1. If equipped, connect satellite wire (2) connector (1).
2. Replace seal if necessary.
3. Connect CHMSL wire.
4. Wipe ends of liftgate with alcohol to clean surface for foam spacers.
5. Remove tape liners from foam spacers on ends of spoiler.
6. Place spoiler (5) onto vehicle (4).
7. Press center push pin into center hole in liftgate.
8. Install four spoiler nuts (3) onto spoiler studs.
9. Install spoiler plugs.
10. Press spoiler above spacers to adhere tape to liftgate.
11. Install liftgate upper molding Installation.

SRT 4





1. If equipped, connect satellite wire (2) connector (1).
2. Connect the washer hose (3) to the washer nozzle.
3. Connect the electrical connector (2) to the center high mount stop lamp and make sure the harness is install to the clip on the spoiler.

NOTE: Make sure the adhesive patch areas are completely clean prior to installation of the spoiler. Due not touch any part of the adhesive tape once the cover strips have been removed.

4. Remove the adhesive cover strips, install spoiler (4) to the lift gate and press down on the areas of the spoiler that have the adhesive patches installed.
5. Install the four nuts (1) to the spoiler studs.
6. Install the body plugs.
7. Install the liftgate upper molding Installation.