Cylinder Head Cover - Installation

INSTALLATION





1. Install new cylinder head cover gaskets (1,2).




2. Install studs in cover as shown.




3. Clean all RTV from cylinder head.
4. Apply RTV to cylinder head/front cover joint.
5. Install cylinder head cover assembly to cylinder head and install all bolts, ensuring the studs are located as shown.
6. Tighten bolts in sequence shown in Using a 2 step torque method as follows:
a. Tighten all bolts to 4.5 Nm (40 in. lbs.)
b. Tighten all bolts to 10 Nm (90 in. lbs.).




7. Install ignition coils. Tighten fasteners to 8 Nm (70 in. lbs.).
8. Connect coil (1) electrical connectors.
9. Connect PCV hose (5).
10. Connect make-up air hoses (2) to cylinder head cover.
11. Install engine cover.