P0320

Tests 296 -301:

Tests 302 - 306:

Tests 307 - 310:

Tests 311 - 316:

Tests 317 - 321:

Tests 322 - 325:

SYMPTOM
P-0320 NO CRANK REFERENCE SIGNAL AT PCM

WHEN MONITORED
4 Cylinder: During engine cranking, with battery voltage less than 11.5 volts and manifold vacuum present. 6 Cylinder: With the ignition in either the start or run position and battery voltage between 4-15 volts.

SET CONDITION
4 Cyl: No signal from crankshaft position (CKP) sensor during engine cranking or there is a camshaft position sensor signal w/o a CKP sensor signal. 6 Cyl: No crankshaft position sensor signal is detected When engine vacuum present or cam signals present.

POSSIBLE CAUSES
- CKP def
- CKP sensor ground circuit open
- CMP def
- Crankshaft position sensor defective
- Crankshaft notches damaged
- Flywheel damaged
- 8-volt supply circuit open
- 8-volt supply circuit short to ground
- CKP sensor signal circuit open
- CKP sensor signal circuit short to ground
- CMP & CKP sensor wiring harness intermittent def
- CMP & CKP sensor wiring harness observable def
- PCM def (No crank)
- PCM Defective (CMP and CKP)