Verification Test VER-2A - Road Test Verification

Inspect the vehicle to ensure that all engine components are connected. Reassemble and reconnect all components as necessary.

If This Verification Procedure Is Being Performed After A No Trouble Code Test, Do The Following:
1. Check to see if the initial symptom still exists.
2. If the initial or another symptom exists, the repair is not complete. Check all pertinent Technical Service Bulletins and return to TEST NTC-1A if necessary. No Trouble Code (NTC) Tests

If This Verification Procedure Is Being Performed After A Trouble Code Test, Do The Following:
For previously read trouble codes that have not been dealt with, return to DTC TEST and follow the path specified. Otherwise, continue.

If The Powertrain Control Module Has Not Been Changed:
1. Connect the DRB or equivalent scantool to the PCM data link connector and erase trouble codes.
2. With the DRB or equivalent scantool, reset all values in the adaptive memory.
3. Disconnect the DRB or equivalent scantool.

Ensure No Trouble Code Remains By Doing The Following:
1. If this test is for an A/C Relay control circuit code, drive the vehicle for at least five minutes with the A/C ON. For some of the drive, go at least 40 mph; at some point stop the car and turn the engine off for at least 10 seconds; then restart and continue. Ensure the transmission shifts through all gears. Upon completion of the road test, turn the engine off and read trouble codes with the DRB or equivalent scan tool.
2. If the repaired code has reset the repair is not complete. Check all related Technical Service Bulletins and return to DTC Test if necessary. If another code has been set, return to DTC Test and follow the path specified for that code. If there are no trouble codes, the repair was successful and is now complete.