Wiper Arm Linkage - Removal

REMOVAL






NOTE: The wiper motor can be removed from the wiper linkage module and is serviced independently from the remainder of the wiper linkage module for this vehicle. Wiper Motor - Removal .

1. Disconnect and isolate the battery negative cable.
2. Remove both wiper arms from the wiper pivots. Wiper Arm - Removal.
3. Remove the cowl plenum cover/grille panel from over the wiper module (2). Cowl Panel Cover - Removal.
4. Remove the foam mucket (3) from the left wiper pivot cup.
5. Disconnect the wire harness connector (6) from the connector receptacle for the wiper motor.
6. Remove the two screws (1) that secure the module bracket to the cowl.
7. Pull the wiper linkage module toward the outboard side of the vehicle far enough to disengage the knob-like rubber isolator (5) from the slotted bracket (4) on the front shock tower brace.
8. Remove the wiper linkage module from the cowl as a unit.