In-Car Temperature Sensor - Removal

REMOVAL

WARNING: Disable the airbag system before attempting any steering wheel, steering column or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to follow these instructions may result in accidental airbag deployment and possible serious or fatal injury.

NOTE: Take the proper precautions to protect the face of the steering column opening cover from cosmetic damage while performing this procedure.





1. Disconnect and isolate the negative battery cable.
2. Remove the steering column opening cover (3) and place it on a workbench Steering Column Opening Cover - Removal.
3. Remove the two screws (1) that secure the in-car temperature sensor (2) to the steering column opening cover and remove the sensor.