Instrument Cluster - Installation

INSTALLATION

WARNING: Wait two minutes for the airbag system reserve capacitor to discharge before beginning any airbag system or component service. Failure to do so may result in accidental airbag deployment, personal injury or death.

CLUSTER ASSEMBLY






NOTE: If the cluster has been replaced, the replacement cluster should be programmed with the correct mileage. Verify the correct mileage via WiTech/Scan Tool.

1. Position cluster into instrument panel opening.
2. Connect the cluster electrical connector.
3. Tilt the cluster forward, install and tighten the upper and lower fasteners (1 and 3).





4. Position the steering column opening seal (4), and press into place.
5. Install the steering column cover, Steering Column Opening Cover - Installation
6. Install the two small instrument panel trim panels (3).
7. Position the upper hood (2) on the instrument panel, and press into place engaging the clips that secure the hood.
8. Connect the battery negative cable.

CLUSTER LENS, HOOD AND MASK





1. Working around the perimeter of the left or right cluster lens, and hood assembly engage each of the latches that secure the unit to the cluster assembly.
2. Working around the perimeter of the lens, hood, and mask assembly engage each of the latches that secure the unit to the cluster assembly.
3. Install the cluster assembly into the instrument panel, 1.