Instrument Panel Center Bezel - Installation

INSTALLATION





1. Before proceeding with the following repair procedure, review all warnings and cautions
2. Position the center bezel near the instrument panel.
3. Connect the harness connectors (2, 3 & 4) from the rear of the display screen (1).
4. Connect the clock harness and align the center trim bezel to the instrument panel.





5. Install the center bezel (1) onto the instrument panel (2) and carefully push on the outside edges of the center bezel to fully seat the snap clip retainers into the instrument panel.





6. Connect and install the telematics gateway assembly (1), Telematics Gateway Module - Installation.





7. Connect and install the AC/heater control faceplate (2) to the I/P, Instrument Cluster Switch Pod - Installation.
8. Connect the negative battery cable.