A/C Expansion Valve - Installation

INSTALLATION

CAUTION: Be certain to adjust the refrigerant oil level when servicing the A/C refrigerant system Refrigerant Oil Level . Failure to properly adjust the refrigerant oil level will prevent the A/C system from operating as designed and can cause serious A/C compressor damage.

NOTE: When replacing multiple A/C system components, see the Refrigerant Oil Capacities chart to determine how much oil should be added to the refrigerant system Refrigerant Oil Level .

NOTE: Replacement of the refrigerant line O-ring seals and gaskets is required anytime a refrigerant line is disconnected. Failure to replace the rubber O-ring seals and metal gaskets could result in a refrigerant system leak.

NOTE: LHD model shown. RHD model similar.





1. Remove the tape or plugs from the evaporator tube fittings and all of the expansion valve ports.
2. Lubricate new O-ring seals with clean refrigerant oil and install them onto the evaporator tube fittings. Use only the specified O-ring seals as they are made of a special material for the R-134a system. Use only refrigerant oil of the type recommended for the A/C compressor in the vehicle.
3. Install the A/C expansion valve (2) onto the evaporator tube tapping block.
4. Install the two bolts (1) that secure the A/C expansion valve to the evaporator tube tapping block. Tighten the bolts to 11 Nm (97 in. lbs.).





5. Remove the tape or plugs from the suction and liquid line fittings.
6. Lubricate a new seal with clean refrigerant oil and install onto the suction and liquid line fittings. Use only the specified seal as it is made of a special material for the R-134a system. Use only refrigerant oil of the type recommended for the A/C compressor in the vehicle.
7. Connect the A/C suction line (7) and the A/C liquid line (8) to the A/C expansion valve (1).
8. Install the nut (9) that secures the refrigerant line tapping block (10) to the A/C expansion valve. Tighten the nut to 23 Nm (17 ft. lbs.).
9. Install the bolt (5) that secures the refrigerant line mounting bracket (6) to the left front shock tower (4). Tighten the bolt to 11 Nm (97 in. lbs.).
10. Connect the wire harness (3) to the A/C pressure transducer (2).
11. Reconnect the negative battery cable.
12. Evacuate the refrigerant system Refrigerant System Evacuate.
13. Adjust the refrigerant oil level Refrigerant Oil Level.
14. Charge the refrigerant system Refrigerant System Charge.