Oil Pump Pick-up - Installation

INSTALLATION





1. Lubricate the new O-ring seal (1) with clean engine oil and install the O-ring onto the oil pump pick-up tube.





2. Position the oil pump pick-up tube (1) onto the oil pump and install the retaining bolt (2) finger tight.
3. Install the oil pump pick-up tube support bracket retaining bolt (3) and tighten to 12 Nm (9 ft. lbs.).
4. Tighten the oil pump pick-up tube retaining bolt (2) to 12 Nm (9 ft. lbs.).
5. Install the oil pan Engine Oil Pan - Installation.
6. If removed, install the oil filter and fill the engine crankcase with the proper oil to the correct level Service and Repair





7. Connect the negative battery cable (1) and tighten nut to 5 Nm (45 in. lbs.).
8. Run the engine until it reaches normal operating temperature and check for leaks.