Rear Panel

ADJUSTMENTS




Figure 1 - DUAL PANE SUNROOF GLASS ADJUSTMENT





1. Open the sunshade fully.
2. Verify the sunroof glass panel is in the fully closed position.
3. Separate the mechanism covers from the tabs on the glass panel.
4. Loosen the attaching screws on each side of the rear glass panel enough to permit adjustment of the glass gap and flush.
5. Loosen the attaching screws on each side of the front glass panel enough to permit adjustment of the glass gap and flush.

NOTE: Use shims to maintain gap during the flush adjustments.

6. Adjust the front edge of the front glass gap to 3 mm (0.12 in.).
7. Adjust the front surface of the front sunroof glass panel 0.00 mm to 2.5 mm (0.00 in. to 0.10 in.) below the top surface of the roof.
8. Tighten the front glass panel attaching screws to 4.5 Nm (40 in. lbs.).
9. Adjust the rear surface of the front sunroof glass panel flush with the top surface of the roof.
10. Tighten the remaining front glass panel attaching screws to 4.5 Nm (40 in. lbs.).

NOTE: Use shims to maintain gap during the flush adjustments.

11. Adjust the front edge of the rear glass gap 3.5 mm (0.12 in.) minimum to 4.0 mm (35.5 in.) maximum.
12. Adjust the rear surface of the rear sunroof glass panel 0.00 mm to 2.5 mm (0.00 in. to 0.10 in.) above the top surface of the roof.
13. Tighten the rear screws of the rear glass panel to 4.5 Nm (40 in. lbs.).
14. Adjust the front surface of the rear sunroof glass panel 0.00 mm to 2.5 mm (0.00 in. to 0.10 in.) below the top surface of the front glass panel.
15. Tighten the remaining rear glass panel attaching screws to 4.5 Nm (40 in. lbs.).
16. Check for proper fit. If not OK, repeat glass panel adjustment.
17. Position the mechanism covers over the glass tabs between the locating features and seat fully.
18. Verify sunroof operation and alignment.