Front Bumper Fascia - Removal

REMOVAL






NOTE: Base model shown, SRT models similar.

1. Disconnect the negative battery cable.
2. Raise and support the vehicle.
3. Remove the fastener (1) that secure the front fascia assembly to the fender.
4. Remove the three fasteners (2) that secure each front wheel house splash shield to the front fascia assembly.
5. Repeat the removal steps for the opposite side.





6. Remove the rear belly pan (1), Belly Pan - Removal.





7. Remove the front belly pan (2), Belly Pan - Removal.





8. If equipped, disconnect the harness (2) from the fog lamps (1). Repeat on the opposite side.





9. Lower the vehicle.
10. Remove the upper radiator deflectors.
11. Pull out on the fascia at the upper fender to disengage the fascia (1) from the upper fender retaining bracket. Repeat on the opposite side.
12. Pull out on the fascia at the wheel house opening to disengage the fascia (2) from the fender retaining bracket. Repeat on the opposite side.





13. Remove the eight fascia to radiator support fasteners (1).
14. With the help of an assistant, remove the fascia (2) from the vehicle.