Power Steering Pump - Installation

3.6L ENGINE






NOTE: Before installing power steering pressure hose on power steering pump, replace O-ring on end of power steering pressure hose. Lubricate O-ring using clean power steering fluid.

1. Install power steering pump (1) onto its mounting bracket.
2. Install three power steering pump mounting bolts through pulley (not shown in figure). Tighten pump mounting bolts to 30 Nm (22 ft. lbs.).
3. Install power steering pump pressure fitting (2) and tighten to 32 Nm (24 ft. lbs.).





4. Slide fluid supply hose onto pump (3) fitting and install clamp (1) securing it in place.





5. Install heat shield (1) and secure with 3 mounting bolts (2). Tighten bolts to 25 Nm (18 ft. lbs.)
6. Lower vehicle.
7. Install accessory drive belt Serpentine Accessory Drive Belt - Installation
8. Connect negative (-) battery cable on negative battery post.
9. Fill and bleed power steering system . Service and Repair
10. Inspect for leaks.