Intake And Exhaust Valves - Installation

INSTALLATION





1. Coat the valve stems (2) with clean engine oil and install the valves into the cylinder head.

NOTE: If the valves are being reused, reassemble them into their original locations.

2. If the valves or valve seats have been refinished, check the valve tip height (5). If the valve tip height (5) exceeds the specification, grind the valve tip until it is within specification Specifications. Make sure the measurement is taken from the cylinder head surface (7) to the top of the valve stem (2).





3. If removed, install the spring seat (3) and valve guide seal (1) over the valve guide Valve Guide Seals - Installation.

NOTE: Ensure that the garter spring (2) is intact around the top of the valve guide seal (1). Number 5 cylinder exhaust valve guide seal shown, all other valves similar.






4. Install the valve spring(s) (2)Valve Springs - Installation.

NOTE: Reassemble the valves springs into their original locations. If the valves or valve seats have been refinished, verify that the valve spring installed height is within specification Specifications. Number 5 cylinder exhaust valve spring shown, all other valves springs similar.

5. Install the cylinder head(s) Cylinder Head - Installation