Hydraulic Lifter - Installation

INSTALLATION






NOTE: The LH cylinder head hydraulic lifters are shown, the RH cylinder head hydraulic lifters are similar. If the hydraulic lifters are being reused, reassemble them into their original locations.

1. Verify that the hydraulic lifters are at least partially full of oil. There should be little or no plunger travel when the hydraulic lifter is depressed.
2. Install the hydraulic lifter(s) (1).

NOTE: If the rocker arms are being reused, reassemble them into their original locations.

3. Install the rocker arm(s) Valve Rocker Arm - Installation.
4. Install the camshaft(s), phasers, cylinder head cover(s) and upper intake manifold Camshaft - Installation
5. Connect the negative battery cable and tighten nut to 5 Nm (45 in. lbs.).