Rear Crankshaft Oil Seal - Installation

INSTALLATION

Special Tools:











CAUTION: If a burr or scratch is present on the crankshaft edge (chamfer), cleanup with 800 emery cloth to prevent seal damage during installation of new seal. If emery cloth is used, the crankshaft must be cleaned off Mopar(R) brake parts cleaner.

NOTE: When installing seal, lubricate Seal Guide with clean engine oil.

1. Place Seal Guide (3) on crankshaft.
2. Position seal (2) over guide tool. Guide tool should remain on crankshaft during installation of seal. Ensure that the lip of the seal is facing towards the crankcase during installation.
3. Drive the seal into the block using Seal Driver (1) and Driver Handle (4) until Seal Driver bottoms out against the block.





4. Install the flexplate (1) and transmission Flexplate - Installation.