Front Bumper Fascia - Installation

INSTALLATION






NOTE: Avenger shown, Sebring similar.

1. Position the fascia to the vehicle.
2. Align and hand tap the fascia sides to engage the fascia retaining tabs.
3. Install the four fascia to upper radiator support push pins (1).





4. On Sebring models, install the front outboard fastener (1). Tighten the fastener securely. Repeat on the opposite side.





5. On Avenger models, install the front outboard push pin fastener (1). Repeat on the opposite side.
6. Raise the vehicle.
7. Install the fender to fascia fastener (2). Tighten the fastener securely. Repeat for the opposite side.
8. If equipped, connect the fog lamps.
9. Install the fascia lower closeout panel, Front Lower Fascia Closeout - Installation.
10. Install the front splash shield, Splash Shield - Installation.
11. Lower the vehicle.
12. Connect the negative battery cable.
13. Close the hood.