Power Steering Pump - Installation

2.0L/2.4L ENGINE





1. Using a lint free towel, wipe clean the open power steering pressure hose end and the power steering pump port. Replace any used O-rings with new. Lubricate the O-ring with clean power steering fluid.
2. Place the pump in mounting position. Install the three bolts (1) through the pulley (3) openings. Tighten the mounting bolts (1) to 26 Nm (19 ft. lbs.).
3. Install the drive belt (2). Serpentine Accessory Drive Belt - Installation





4. Install the supply hose (1) at the pump (3).
5. Clamp the hose clamp (2) securing the supply hose (1) to the pump.





6. Install the pressure hose (3) at the pump pressure port (5). Tighten the tube nut to 32 Nm (24 ft. lbs.).
7. Install the pressure hose routing bracket bolt (2) to the engine mount (8). Tighten the bolt to 24 Nm (18 ft. lbs.).
8. Fill and bleed the power steering system. Power Steering System Bleeding
9. Check for leaks.
10. Install the engine appearance cover.