Cylinder Head Cover(s) - Installation

INSTALLATION





1. Install new cylinder head cover gaskets (1,2).





2. Install studs in cover as shown.





3. Clean all RTV from cylinder head Procedures.

NOTE: When using RTV, the sealing surfaces must be clean and free from grease and oil.

NOTE: When using RTV, parts should be assembled in 10 minutes and tighten to final torque within 45 minutes.

4. Apply a dot of Mopar(R) engine sealant RTV or equivalent to cylinder head/front cover T-joint (1).





5. Install cylinder head cover assembly to cylinder head and install all bolts, ensuring the studs are located as shown.
6. Tighten bolts in sequence shown using a 2 step torque method as follows:
a. Tighten all bolts to 5 Nm (44 in. lbs.).
b. Tighten all bolts to 10 Nm (90 in. lbs.).





7. Install ignition coils. Tighten fasteners to 8 Nm (70 in. lbs.).
8. If the PCV valve was removed, tighten PCV valve to 5 Nm (44 in. lbs.).
9. Connect coil electrical connectors (1).
10. Connect PCV hose (5) to PCV valve.
11. Connect make up air hose (2).





12. Connect negative battery cable.
13. Install engine cover (1) by pressing the rear of the cover down first.