Installation

INSTALLATION





1. Raise the vehicle on the hoist.
2. Install a NEW 2/4 clutch oil seal (1).




3. Install new O-rings (1) on the underdrive compounder assembly oil transfer tubes (2).




4. Insure the manual lever is fully forward to keep the manual valve pin (3) from binding.
5. Set the manual valve pin (3) into the slot in the rooster comb.
6. Set the valve body into the underdrive compounder assembly oil transfer tubes (2) and press the valve body into place.




7. Install the twenty one valve body to case bolts and tighten to 6 Nm (50 in. lbs.).




8. Install the detente arm (1) onto the pin at the valve body.
9. Install the screw (3) at the detente arm and tighten to 6 Nm (50 in. lbs.).




10. Install the electrical connector (1) at the valve body.
11. Lower the hoist.




12. Install the valve body oil pan, use a bead of MOPAR(R) ATF RTV (MS-GF41).
13. Install the upper valve body oil pan bolts and tighten to 6 Nm (50 in. lbs.).
14. Install the pressure tap at valve body oil pan and tighten to 6 Nm (50 in. lbs.).
15. Lower the vehicle on a hoist.




16. Install the solenoid pack connector (2) at valve body oil pan.
17. Raise the vehicle on the hoist.




18. Install the lower valve body oil pan bolts and tighten to 6 Nm (50 in. lbs.).
19. Install the left side inner wheel splash shield screws (1).
20. Lower the vehicle.




21. Install shift cable (1) to manual lever (2).
22. Install lower radiator hose and clamps.
23. Fill the cooling system Service and Repair.
24. Install the battery cable.
25. Fill transmission and road test Fluid Level and Condition Check - 62TE.