Heated Seat Element - Removal

REMOVAL





NOTE: Do not remove the factory installed heating elements from the seat cushion (3) or seat back foam. The original element is permanently attached and cannot be removed without permanent damage. The replacement heating element is designed to be applied directly on top of the inoperative factory installed heating element.

NOTE: Heated seat cushion shown, heated seat back similar.

1. Disconnect and isolate the battery negative cable.
2. Remove the appropriate seat cushion trim cover, Service and Repair or seat back trim cover, Seat Back Cover - Removal.
3. Disconnect the inoperative heated seat cushion or seat back element electrical connectors (2).
4. Locate the wires leading from the inoperative heating element and cut them off flush with the edge of the original heating element.