A/C Heater Control - Removal

REMOVAL

WARNING: Disable the airbag system before attempting any steering wheel, steering column, or instrument panel component diagnosis or service. Disconnect and isolate the negative battery (ground) cable, then wait two minutes for the airbag system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the airbag system. Failure to take the proper precautions could result in accidental airbag deployment and possible personal injury or death.





1. Disconnect and isolate the negative battery cable.
2. Remove the console bezel (1) and place it on a workbench Center Console Bezel - Removal.
3. Remove the four screws (2) that secure the A/C-heater control (3) to the back of the console bezel and remove the control.