Installation

INSTALLATION





NOTE: If valve body assembly is being replaced or reconditioned, it is necessary to perform the PCM Quick Learn Procedure Quick Learn Procedure.

1. Install underdrive (2) and overdrive (1) accumulators.




2. Install valve body assembly (1) to transaxle.




3. Install and tighten valve body-to-transaxle case bolts.




4. Install transaxle oil filter (1). Inspect the O-ring (2) and replace if necessary.




5. Ensure the transaxle oil pan and transaxle case sealing surfaces are clean and dry. Install a 1/8" bead of Mopar(R) ATF RTV (MS-GF41) to the oil pan and install.




6. Torque oil pan-to-transaxle case bolts to 19 Nm (165 in. lbs.).
7. Lower vehicle.
8. Connect transmission range sensor connector.
9. Install manual valve lever to manual shaft.
10. Install gearshift cable to manual valve lever.
11. Connect battery negative cable.
12. Fill transaxle with Mopar(R) ATF +4 Transmission fluid. Fluid Level and Condition Check - 40/41TE.